Circle Jig on A Band Saw

while it is genuine that a band noticed is straightforward to apply and can produce numerous pieces for any projects, one of the toughest challenges in relation to band noticed reducing is making a circle out of a square formed piece of timber. Doing it in loose hand requires numerous concentration and first rate hand and eye coordination. however, even the maximum experienced band noticed operators still fail to make an excellent circle with this technique.

To make things extra correct and efficient, the use of a circle jig on a band saw is way higher than using a compass and drawing a circle to run it in freehand. A circle jig is an accent this is attached to the band noticed desk. some of its maximum vital components incorporate the dove tail slider that may be adjusted depending at the diameter of the circle and the pivot point which is where the center of the wooden piece is connected and turns because it runs at the blade.

Getting The proper Set-up

It is important to set-up the circle jig nicely at the band noticed desk to create an excellent circle. truly observe these steps to set it up effectively.

1.            The cleat that can be discovered at the bottom of the circle jig should grow to be at the brink of the band saw table.

2.            Slide the pivot factor as close as viable to the blade and carefully inspect at eye degree to make certain that the center of the pivot point is aligned on the very the front of the band noticed blade.

3.            Lock the cleat to secure its grip at the desk.

reducing Circles on timber materials

Now that the circle jig is securely and accurately placed at the band noticed desk, it is time to make some cuts. however, to keep away from wasting materials on imperfect circles, try doing a test reduce first.

1.            so that it will latch the wood cloth to the circle jig, make a hole in center of the bottom part of the wooden. This hollow ought to match flawlessly to the pivot factor.

2.            adjust the dove tail slider so that the brink of the wood is most effective touching and no longer pushing on the blade. make sure to lock the slider the use of the slider knob located at the lowest of the circle jig.

3.            put on your defensive gadgets together with goggles and ear plugs and activate the band saw. carefully turn the timber because it runs via the band noticed blade.

four.      Rotate the wooden lightly till you create a whole circle.

five.       After the take a look at cut, take a look at if it cuts a super circle or if there is any want for a few great tuning or changes within the set up to create a better circle.

6.            as soon as that is achieved, it's time to do the very last reduce. absolutely comply with steps 1 to a few once more and maintain with the subsequent steps.

7.            try cutting a small element at the threshold of the timber that is simply sufficient to match the blade. this will help produce a greater best circle.

8.            as soon as it's miles finished, you can finally use the piece for any of your tasks.

that is perfect for excessive quantity of initiatives with round portions along with desk tops and bowl blanks. With the usage of circle jig, each reduce is ensured correct and the overall output is green with out losing too many substances on mistakes. even though the usage of the compass to attract a circle is also a good way to reduce a circle, using a circle jig makes the paintings greater handy for you.